Guide :Home : Waterpik& Elements& Handheld Showerhead

Water pressure drops after a few seconds to almost nothing...

I removed all of the pieces and the water flow is fine until I hook the hose up. The water comes out just fine for a few seconds and then reduces to almost a trickle, you can barely shower. There is no debris in the set-up.

Research, Knowledge and Information :


Why would I run out of water for a few seconds and then get ...


After 2-30 seconds the water ... Why would I run out of water for a few seconds and then get full ... If you have well water, you almost certainly have a pressure ...
Read More At : diy.stackexchange.com...

What would cause the water pressure to be too high for just a ...


What would cause the water pressure to be too ... After a second the pressure drops way down now ... Why would I run out of water for a few seconds and then get ...
Read More At : diy.stackexchange.com...

How to Diagnose Water Pressure that Comes and Goes Bad - What ...


Water pump and water water pressure tank pump cycling ... water pressure returns, but water pressure drops without explanation ... and held it for a few seconds ...
Read More At : www.inspectapedia.com...

Diagnose & Repair Slowly-Dropping Water Pressure


... How to Diagnose & Repair Slowly-Dropping Water ... If water pressure drops after the ... and it slowly drops a few psi while about 10 more seconds ...
Read More At : www.inspectapedia.com...

Cold/Hot Pressure Starts Strong Then Fades - DoItYourself.com ...


Cold/Hot Pressure Starts Strong Then ... faucets starts off strong then fades after 1-2 seconds. ... would be to determine what the water pressure is entering ...
Read More At : www.doityourself.com...

Hot Water Shower Pressure Starts Strong Then Fades


Hot Water Shower Pressure Starts Strong Then ... do so when it is under flow so the few seconds of 'decent' pressure they get is ... the 'hot water pressure valve ...
Read More At : www.propertytalk.com...

Why would the water pressure from your well start out strong ...


Why would the water pressure from ... If the pressure is good right away, but almost seems to "spray" out of the faucet and then after just a few seconds drops to ...
Read More At : www.answers.com...

Gas pressure washing tech? Pressure for just a second then ...


Jun 07, 2011 · Gas pressure washing tech ... pressure for just a second then it drops off to nothing. ... except for the first few seconds after you pull the ...
Read More At : www.pirate4x4.com...

What Causes Low Water Pressure in My House? | Angie's List


What Causes Low Water Pressure in My ... your problems with water pressure may have nothing to do with your ... A sudden drop in water pressure in usually means it ...
Read More At : www.angieslist.com...

Reasons for Water Pressure Drop | Hunker


A drop in water pressure, whether sudden or gradual, can make everyday life miserable. Many people do not know the reasons for a loss of water pressure. Unscrupulous ...
Read More At : www.hunker.com...

Suggested Questions And Answer :


Water pressure drops after a few seconds to almost nothing...


In the hand held shower head where the hose attaches to shower head. In the head there could be a flow restrictor. It may be rubber or plastic. In some cases you can remove it, or check if something is blocking it. Also try running the shower without the head on to see if there is some debris in the hose, and to check your water flow.
Read More At : Waterpik& Elements& Handheld Showerhead...

No water flow through the showerhead bracket


Blow air through the part that attaches to the bracket and see if there is any air coming out if not you probably have a clog in the tube or the head.
Read More At : Waterpik& Elements& Handheld Showerhead...

Hot and cold water in shower comes out in a triclkle


Shut off the water from the main pipe. use a allen screw driver take the handle off the shower control. pull of the wall cover. pull out the pin that stablized the cartridge in the control body. (remember how it is, before you take it out. or take a digital pic of it). pull out the cartridge. and bring it to any home center or plumbing store. install in reverse.
Read More At : Waterpik& Elements& Handheld Showerhead...

I have one turn handle in the shower. When I turn it to the right for cold wter, the cold water comes out fine - good pressure. When I turn it to the left to get some hot water, the water goes down to a messy, low pressure type trickle. What is the problem? Can I fix it myself? If so, how? I really have no experience with plumbing.


Alot of newer shower controls have a tempering valve on them. You need to open up the front of the unit (hopefully you have your owners manual and adjust the inner workings) this should solve your problem
Read More At : Waterpik& Elements& Handheld Showerhead...

For my Water Pik Model WP-20W switch no longer turns on WaterPik


Well, either the switch has gone bad or the pump is stuck. You can use 2 table spoons of white vinegar with a full reservoir of hot, hot tap water. Let it set over night and try to run it in the morning. If the pump is "gummed" up it should free it and allow it to run. Clean again if necessary. Other than that, you can take it apart. I took mine apart and cleaned it once, before I found out about the vinegar. Most of the time it is the pump that is frozen. Good luck and let me know.
Read More At : Waterpik& Elements& Handheld Showerhead...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0376 seconds