Guide :Home : & Posi-Temp Single Handle Shower Or Tub Valve

MOEN POSI-TEMP GOES FROM HOT TO COOL AFTER 30 SECONDS OR SO

THE 2 OTHER SHOWERS IN MY HOUSE WORK JUST FINE. THIS FAUSET WORKS OK IN THE SHOWER POSITON BUT IN THE BATH FILL POSITION IT SWITCHES TO COOL IN LESS THAN A MINITE. IF I TURN THE WATER OFF AND WAIT FOR ABOUT A MINITE IT COMES OUT HOT THAN GOES COOL AGAIN. I PUT A NEW INSERT IN THE FAUSET BUT DIDN'T HELP ANY. ANY IDEAS?

Research, Knowledge and Information :


LEFT WITH HOMEOWNER POSI-TEMP TUB AND SHOWER VALVES - Moen


This valve is equipped with the Moen long-life POSI-TEMP cartridge, ... let the water run for several minutes to purge cool water from the hot water ... 15 seconds ...
Read More At : www.moen.com...

MOEN Posi-Temp Pressure Balanced Shower Cartridge-1222 - The ...


MOEN Posi-Temp Pressure Balanced Shower Cartridge is designed for use with Moen ... Replaces MOEN Posi-Temp ... but by a week was flowing so fast (hot water) ...
Read More At : www.homedepot.com...

MOEN Brass Rough-In Posi-Temp Pressure-Balancing Cycling Tub ...


Upgrade the style of your bathroom using this Rough-in Posi-Temp Pressure-Balancing Cycling Valve designed by MOEN. Features brass construction.
Read More At : www.homedepot.com...

Moen Frequently Asked Questions (FAQs) | Moen


Frequently Asked Questions. ... on my Posi-Temp shower, I get scalding hot ... to be cut to the desired height after it has been installed? Does Moen make a ...
Read More At : www.moen.com...

Shower Valve Options - Moen


All so you can use Moen with confidence. ... Moen Shower Valves AT A GLANCE Posi-Temp ... No need to readjust temperature as hot water tank begins to cool.
Read More At : pro.moen.com...

Moen 8342 Commercial Two-Handle Shower Only without Tub Spout ...


Moen 8342 Commercial Two-Handle Shower Only ... It started dripping about a month after is was installed by a plumber so I ... Moen T8342 Commercial Posi-Temp ...

Frequently Asked Questions (FAQs) Regarding Moen Faucets


Consumer Support Frequently Asked ... If this is the way your Moen valve operates, any Posi-Temp trim will ... controls the water flow rate so you get the amount of ...
Read More At : www.moen.ca...

Water temperature fluctuates in shower every time, ideas ...


Water temperature fluctuates in shower ... dips and becomes cool, then after another ... what you need is a moen posi-temp faucet, which balances the hot and ...
Read More At : www.reddit.com...

Suggested Questions And Answer :


Posi -temp shower fixture. Can't seem to regulate the hot water. When the hot tank rest over night its temperature goes down. So if you take a shower in the morning then only luke warm water at best. During when the hot water tank is used for other household applications ( more daytime use) the hot water has a higher temperature and you have turn the shower down (add cold water) or else it becomes too hot. So how can we regulate the shower temperature? I'm having the hot water tank inspected for its operation but is there other solutions we should be looking at? thanks for your advice-- liard_acres


That sounds like the thermocouple within the heater to me.There are 2 sections within the thermocouple.A reference section(what you want it to be) and an actual reading section.The difference between the 2 twists 2 pieces of metal which are different elements and causes a signal to activate/deactivate heater.It is simple but surprisingly accurate usually within 2 degrees F.Whatever is going on,it seems awful backwards.Checking the heater is definitely the best first choice.The shower hood is not likely to affect the system unless it had it's own heat or something.That is not the 'normal'function though.Also,after you do get it fixed,we have our water temperature set so that taking a shower requires very little cold water.Saves on water and power because hot hot water is only really needed if you have infants.Ours may be about 140F,150F,160F,don't remember exact and it's hard to access.Set a temp and let sit 24 hours and try it after it's fixed.Probably adjust in about 10 or 15 degree increments,depending how far off it feels compared to what is tolerable.Good luck,Greg If you have any questions or need more help,just comment here and I will get an autolink to your post and reply ASAP.Greg
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

MOEN POSI-TEMP GOES FROM HOT TO COOL AFTER 30 SECONDS OR SO


Wow A Mystery Faucet!!! SOUNDS LIKE THE WATER LINES FEEDING THE FAUCET MAY BE SWITCHED. CHECK TO MAKE SURE THE COLD FEED GOES TO THE COLD SIDE AND THE SAME FOR THE HOT. SOMETIMES MISTAKES ARE MADE WHEN INSTALLING THE FAUCET. MAKE SURE THEY ARE CONNECTED THE SAME AS THE 2 THAT ARE WORKING. IF YOU HAVE THE TIME AND PATIENCE, YOU CAN TAKE A WORKING FAUCET AND INSTALL IT IN PLACE OF THE (mystery faucet) AND SEE IF YOU HAVE THE SAME RESULTS. IF YOU GET HOT WATER IN THE TEMPORARY FAUCET, THEN YOU HAVE A DEFECTIVE FAUCET. THESE ARE A FEW TROUBLE SHOOTING TIPS I HOPE THAT MAY HELP YOU.....JOE
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

MY Moen single handle shower knob turns in a complete circle. From left clockwise, it goes from hot, tepid, cold, tepid, then back to left-hot. What causes this and how can it be repaired?


It sound like you have a Moen Posi-temp faucet and the handle is broken. It is probably an acrylic hdle with a tear drop shaped cover. Take a knife and slide it under the cover to pry it off. Unscrew the center screw and the handle will pull right off. You will see two shoulders inside the hdle, one of which will be cracked and broken. Replace the hndle which can be purchased at any Lowes or Home Depot. Plumbing supplies also carry replacements, but you can probably get one cheaper at HD or Lowes.. Make sure to use the washer provided. It has two flats on the inside of washer. Slide this over the brass stem on your cartridge, NOT on the hdle screw. Install it with the flats of the cartridge in horiz. position. Try faucet. If the water comes out in the opposite temp you expect, warm is cold, and cold is warm, remove the hdle, spin the stem 180 degrees and reinstall hdle.Good luck!
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

Moen posi-temp for shower pressure


There is a little "o" ring in the shower inlet that is designed to collapse as the pressure increases, limiting flow. You can safely remove this and then have un restricted flow.
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

I get only hot water from the faucet - Moen & Posi-Temp Single Handle Shower Or Tub Valve


Sounds like you have a bad cartridge. take the handle off remove the outer crome trim around the valve body and there should be a copper clip in the bottom or top remove the clip and make sure you have the water off and grab the cartridge and give it a swift pull and it should come right out. you can get the cartridge from moen if you call 1800 buy moen or if you can't wait go to a local suppily house they range from 20-60 bucks depending on what you have
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

When I shower, the handle is at 2:30, and I'd like to be at 12:00 for the perfect mixture. Obviously the water is too hot, but I can't adjust the water heater (gas) temp down or else the hot water in kitchen is not hot enough. I have a Kohler faucet in kitchen...not sure if there is a valve regulating temp there. This is a recent installation & I have access behind the shower.


Here are the instructions for your faucet go down to the adjust temp stop limits section, and your home free Good Luck http://www.moen.com/shared/pdf/instruction_sheets/mt692c.pdf
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

We have a home that is 3 years old. We never used the 3rd bathroom shower until today. We have a Moen single knobe shower/bath valve. To get water from the faucet you pull the knob out. To adjust the water temp - Left for hot and right for cold. When rotated to the left for hot the water shuts off. When rotated to the right we get only cold water. Could the valve be installed wrong or could the cartridge be installed wrong? Kevin


Remove handle to gain acess to the temperature limit stop. Remove handle and pull out handle adapter kit and next there is a dail that can be adjusted to control the water to balance the temp. It could have been installed wrong, pay attention to where it is now and pull it back to it disengages out of the stem and move it counter clockwise a little and reinstall. Put handle on and test water for correct movement. Go to link below for a part's diagram if needed. TO ORDER PARTS CALL: 1-800-465-6130 www.moen.com
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

No water flow


Did this unit come with water stops built into the faucet body? Some of the newer faucets have stops built in and they need to be turned on. Also if you aren't going to plumb the hot in, you will need to cap it off but it should run without it unless it has some sort of balance in it. I don't think so though.
Read More At : & Posi-Temp Single Handle Shower Or Tub Valve...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0830 seconds