Guide :Home : Cadet 3 Right Height Elongated Toilet by - ADA Compliant

Water shut off sticks open

My American Standard has valve in tank (0915A) that sometimes fails to rise the final half inch needed to shut off the water. It never used to do this, and has not been touched. There is no corrosion or build up on the parts.

Research, Knowledge and Information :


How to Open Stuck Plumbing Shut-Offs - YouTube


Oct 24, 2013 · Open stuck plumbing shut-offs with help from a foreman for Lighty Contractors in this ... How to Install a Water Shut off Valve for Beginners ...

Tips for fixing stuck water shut off valves | Roto-Rooter ...


Aug 31, 2013 · Have you ever tried to turn off the water to a sink or a running toilet, only to find that the valve is stuck in place? This is usually caused by the ...

How to Troubleshoot a Stuck Water Shut-off Valve | Hunker


Water shut-off valves are small, oval-shaped metal knobs that open and close water flow to household plumbing devices. There is a separate water shut-off valve for ...
Read More At : www.hunker.com...

Stuck Shut-offs | This Old House


Stuck Shut-offs. An ounce of ... and I'm afraid I'll break something if I ever have to force them closed to shut off my water. ... But once it sticks, ...
Read More At : www.thisoldhouse.com...

How to Free Stuck Plumbing Valves | Home Guides | SF Gate


How to Free Stuck Plumbing Valves. Turn water valves on and off regularly to keep them from ... How to Open Stuck Plumbing Shutoffs; How to Shut Off a Stuck Toilet ...
Read More At : homeguides.sfgate.com...

TMF: Water Shutoff Valves Wont Budge / Building / Maintaining ...


And please know where your whole house water shut off is before you try to open it ... Water Shutoff Valves Wont Budge ... the stuck-ness. Water pressure ...
Read More At : boards.fool.com...

Loosen A Stuck Shut Off Valve | Terry's Plumbing


Stuck shutoff valves can ... to opening a stuck shut off valve is basically a matter of trial and error. Start by turning off the main water shut off valve ...
Read More At : www.superterry.com...

Whirlpool 61003804 - Ice and Water Dispenser Actuator Pad ...


Ice and Water Dispenser Actuator Pad ... (sticks "on") Shut off power, ... Ice chute door did not open when pushing the actuator pad to dispense ice.
Read More At : www.partselect.com...

How do I force a tight globe-valve water shutoff to fully ...


How do I force a tight globe-valve water ... and they are less likely to become stuck open ... This means you have to shut the water off upstream of the valve ...
Read More At : diy.stackexchange.com...

Suggested Questions And Answer :


My brand new toilet american standard round front model cadet 3 tank not fill water


If you verify that the water supply to the toilet is turned on, push down the float on the flush valve. Water should start flowing. If it doesn't, something (such as debris) may be blocking the valve and preventing filling. The new valve could be defective - permanently closed.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Water shut off sticks open


Make sure that the float in not touching the side of the bowl. You may oil the hinge on the float. Lastly you may turn off the water , open the valve and see if any of the internal parts are swollen or enlarged interfering with the final rising of the float, and closing of the valve.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Cadet 3 round bowl toilet not flushing all from bowl


You are probably correct, the water level needs to be raised. There are many different toilet tank systems, but all have some way to control the water level in the tank. Let me know if you need help figuring it out... P.S. You'll have to take the lid off the tank, first...pardon me if that is too obvious
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

American Standard Elongated toilet bowl water level slowly drops


The tank holding the proper amount of water is a good sign. The inside of the stool is like the GOOSE NECK under you sink. It always holds water. This may sound like a bit of a hassle to do but if all 3 toilets are identical, here is what you can try if you are a bit handy. Go to the hardware store and purchase 4 toilet wax rings with a plastic flange and a few sets of toilet floor flange bolts(they are cheap and you can always return if not used, as It is better to have xtra parts on hand). Turn off the water supply to the "Mystery Toilet". Leave the tank and everything connected to the stool. Flush the toilet and remove all excess water from the tank and bowl. This can be done with a shop vac, sponge or towel. Disconnect the water supply to the tank. Remove the bolts holding the stool to the floor and carefully remove toilet. Scrap off all the old wax from the floor flange and bottom of stool. Now go and repeat this proceedure to one of the toilets that is working properly. In other words Switch the "Mystery Toilet" with a "Working Toilet" and see how they react. If the working toilet does it in the same bathroom and the "Mystery Toilet" does not do it in the other bathroom then you probably have a VENTING PROBLEM. If the "Mysery Toilet" Does it in the other bathroom then you most likely have a Defective Toilet. This Job is best done by 2 people, as it can sometimes be challenging to center the new wax ring on the toilet flange. Reconnect to the floor and reconnect water supply to the tanks. DO NOT OVERTIGHTEN BOLTS to the floor flange as you may crack the toilet. All drain lines must be vented properly for water to flow. If you are curious check out drain venting on the internet. Also, sometimes a vent can become obstructed with debris, ice, bird nest, etc.. I would 1st check the vent on the roof visually and then have someone flush and listen. If you believe the vent is clear....Then do the toilet switch and go from there.....Hope this helps and Happy Holidays....Joe
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Need to know which cadet to install--3 or 4


I only install Kohler commodes and have never had a problem with clogging. All of Kohler commodes have a 3.5 inch flush valve, just pick the style you want.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Toilet flushing problem! I purchased an American Standard Cadet 3 High HET toilet (1.28 gallon). When I flush the toilet, the flap will not stay up to allow the water to drain from the tank. When handle is pushed down only about 2 cup full of water enters the bowl resulting in poor flush. I have tried to shorten the chain and increasing the water lever in the tank with no results. In order to get a decent flush I have to hold the handle down, otherwise the flap will fall like a rock. Help!!!


The siphon mechanism works on a vacuum principle. If there is the slightest damage to the siphon membrane you will experience the problem you describe. A new siphon is required.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

I recently bought (9 months ago ) an american standard brand model CADET 3 one piece unit and recently 1 month ago , after flushing the toilet the water fills the up the water tank but there is continuous leaking(dribbling) of water into the the tube and the flushes are no longer as powerful as before. for your info the toilet was installed professionally.....what could be the problem and what recourse is there theunit cost was on speciall for $ 500.00


Theres probably debrie in flush valve, mite also try putting food dye in tank (any color) if it appears in bowl the flapper is seeping water and activating flush valve..
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

How much draw down (tightening) do use to attach the water tank to the toilet bowl on a American Standard Flowise Cadet 3 toilet? Does the tank need to meet the bowl?


Seat the tank well on a new wax ring and then tightnen the two bolts on the sides evenly there is a small amount of pressure but thats it. To much and you'll snap the side of the bowl. You can caulk around the edge if you want more security,less movement. The tension on the nuts is very tricky just a feel kinda thing. Be carefull not to over do it.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0727 seconds