Guide :Home : - Toilet Seat - Moondance - K4717-CP-D8

How do you replace the seat on a kohler lowboy?

Posted by betsy23 on Jan 20, 2009

Research, Knowledge and Information :

How to remove the toilet seat from a Kohler One-piece Model ...

Nov 10, 2013 · How to remove the toilet seat from a Kohler One-piece Model K3434 ... How to replace and install the Kohler Grip-Tight Cachet Q3 Elongated Toilet Seat ...

Toilet Seats | Bathroom | KOHLER

Shop KOHLER toilet seats. ... Need a replacement part but don't know which product you have? Our Product Wizard can get you there in a few quick steps.
Read More At :

Kohler toilet seat replacement for one-piece. | Terry Love ...

I have a one piece kohler toilet and am trying to replace the seat. the problem is that one of the anchor screws will not come out of the toilet. I...
Read More At :


Nov 18, 2013 · SEAT REPLACEMENT KOHLER RIALTO toilet K-3386 dino Dino Pinch. Add to ... How to replace a toilet seat - Duration: 5:08. iScaper1 255,516 views. 5:08

Maintenance & Replacement Parts | KOHLER

Find Maintenance & Replacement Parts for your KOHLER products. ... Use your Facebook account to sign in with KOHLER: ... Where do you primarily purchase plumbing ...
Read More At :

How to Repair a Kohler Toilet | eBay

How to Repair a Kohler ... but they are convenient if the owner needs to replace a ... KOHLER K-4349-96 Wellcomme Elongated Toilet Bowl W/ Rear Spud Less Seat ...

KOHLER - Toilet Parts & Repair - Plumbing Parts & Repair ...

Shop our selection of KOHLER, Toilet Parts & Repair in the Plumbing Department at The Home Depot.
Read More At :

Kohler Rialto Toilet Repair Parts -

Rialto Toilet Repair Parts By Kohler. ... Replace your worn out flush valve or flapper with one from our selection below. ... Seat Anchor Kit ...
Read More At :

Suggested Questions And Answer :

How do you replace the seat on a kohler lowboy?

There are two bolts that are under cover at the back of the seat. feel underneath for the nuts-pop the caps on top w/ a screwdriver. make sure you purchase the correct profile seat Elongated or standard..
Read More At : - Toilet Seat - Moondance - K4717-CP-D8...


They might be expanding fasteners that only need access from the top. Did you pop off the caps on top and loosen the screws with a screwdriver?
Read More At : - Toilet Seat - Moondance - K4717-CP-D8...

Offical low boy toilet seat - Kohler - Toilet Seat - Moondance - K4717-CP-D8

Congratulations on the purchase.
Read More At : - Toilet Seat - Moondance - K4717-CP-D8...

I tried to unscrew a toilet seat on a lowboy now the screws won't screw or unscrew.

If the screws won't turn either way, they're probably "cross-threaded" or stripped. You'll have to unscrew them with force. I'd use a ratchet and socket on an extension (you might want to use a deep socket, since the bolts often extend an inch or two past the nut). Once you get them off & can remove the seat, head to the hardware store or Home Depot & pick up a new set of bolts & nuts. They're very inexpensive. When installing them, make sure that the nuts screw onto the bolts with finger pressure alone, before taking a wrench or pliers to them.If using force to unscrew them ends up damaging the toilet lid/seat assembly (this is the worst-case scenario), then you'll have to spring for a new toilet seat. The up-side of this is that new seat/lid assembly come with the screws and nuts, and - depending on what you want - can cost as little as $15 for an "economy" model, and up to $30-35 or so for a "deluxe" model.
Read More At : - Toilet Seat - Moondance - K4717-CP-D8...

I had to replace the rubber seal mechanism on my K33860A toilet. Now no matter how I adjust the chain the rubber seal seems to pull to the left(as I face the toilet) causing it to run. How can I fasten the seal in place? Thank you

Get the correct part from Kohler. Most hardware parts are close fit, but do not work.
Read More At : - Toilet Seat - Moondance - K4717-CP-D8...

I cannot tighten the toilet seat on my kohler 3386 rialto toilet. Like everyone else I cannot find out how to get to the bottom of the screws. I never would have bought the toilet if I realized you cannot get to the screws to replace the cover. Kohler should replace the seat and all instructions pertaining to this toilet as it apparently is a definite manufacturers slip-up. I have always purchased kohler products but will be real careful in the future. How do i get this rectified?

Give Kohler a call AFTER you read the instructions thoroughly. Good Luck, seriously.
Read More At : 3386-6 Rialto Skylight Round Front Toilet...

Kohler Rialto flap valve leak

If the flappper isn't closing, there is no suction AKA a clog perhaps.
Read More At : 3386-6 Rialto Skylight Round Front Toilet...

How do we replace the seat on a Kohler K-3386-0 Rialto one piece toilet? The screws/nuts holding the seat down are inside the toilet and aren't accessible. Is there a way to replace the seat without having to replace the entire toilet?

Kohler will try to sell you $46 anchor bolt kit 84999 & also there special tool. You should expect that for a $400 toilet. Try this instead: 1. Use 1/8" drill bit and drill and drill around the bolt until the anchor material can be removed. 2. Carefully clean hole with 11/32 drill to remove all remaining acchor material. 3. Go local hardware store & buy a 10 - 32 3/8"X3/4" rubber expansion plug (make certain threaded part is brass & has shoulder on 1 end), a 10 - 32X1.5" Phillips bolt and couple of small fender washers fit the seat.(about $4 for 2) 4. Assemble carefully not to over tighten and crack the porcelain. Hope it helps
Read More At : K-3386-0 Rialto one-piece round-front toilet with seat and......


Hi, Look inside of the tank the number will be stampes into the porcelin of the inside of the tank... heatman101
Read More At : - Toilet - One-piece - Santa Rosa - K3323-52...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0977 seconds