Guide :Home : 2002.014 - Champion4 Right Height Elongated Toilet...

Hole in back of toilet (stool) leaks water.

American Standard. A small hole was placed in rear of the toilet during the manufacturing. I suppose it is some kind of vent. I don't know why it leaks.

Research, Knowledge and Information :


How To Repair a Leaking Toilet | The Family Handyman


How to Repair a Leaking Toilet. ... you'll have the stool back on-line in under an hour. ... Frequently a toilet leaks simply because the wax ring has lost its seal.
Read More At : www.familyhandyman.com...

I have a toilet that began leaking under the stool after about


I have a toilet that began leaking under the stool after about ... Still leaks and water on the floor seems near front, ... Has holes to center it on hold down bolts.
Read More At : www.justanswer.com...

Vent hole in American Standard toilet - DoItYourself.com ...


Hi, All - I have an American Standard toilet that has a hole in the back of the stool about half way down from the tank. It appears to be a vent, but I have water ...
Read More At : www.doityourself.com...

How to Toilet Repair | Ask the Builder


... hard water deposits in the syphon jet hole or the ... "When toilet flushes, get back splash of water that ... the toilet works fine. Is this a water leak, ...
Read More At : www.askthebuilder.com...

Fixing a Toilet and Toilet Troubleshooting | Toilets ...


Fixing a Toilet and Toilet Troubleshooting ... the water inlet holes in the bowl are partially ... that the toilet is leaking dirty water from when the toilet is ...
Read More At : www.home-repair-central.com...

Is Your RV Toilet Leaking? Read This First - RVshare.com


Is Your RV Toilet Leaking? Read This ... It is possible that a leak can be coming from the water connection at the back of the toilet. ... How big is the waste hole? 5.
Read More At : blog.rvshare.com...

How To Fix a Leaking Toilet Tank - Toilet Tank ... - YouTube


Mar 25, 2013 · How To Repair A Toilet That Leaks Or Always Has The Water Running - Duration: 26:29. Jennies Garage 426,580 views. 26:29.

Tips on Solving Common Toilet Problems | DIY


If you hear a sustained hissing sound coming from your toilet, it's probably a result of water trickling ... each flush hole to ... fail and cause smaller leaks.
Read More At : www.diynetwork.com...

Finding & Fixing Toilet Leaks - PlumbingSupply.com


Finding & Fixing Toilet Leaks Water ... back of the bowl inlet hole, or another one may have the low side on one of the sides of the bowl inlet hole. Water ...
Read More At : www.plumbingsupply.com...

Suggested Questions And Answer :


Hole in back of toilet (stool) leaks water.


The hole your refering to is common in the manufacturing of toilets and is generally filled before it leaves the manufacturing. I have repaired several toilets, new toilets, all American Standard, using a good grade of epoxy - not silicone. I used West System epoxy as this is made for marine projects and surprisingly states "toilet repair" as one of the uses of their product. I'd suggest carefully chipping the smooth porcelan around the hole to give the epoxy something to grip. Use a knife or screwdriver to gently chip the edges and make sure the area is dry. Press the epoxy into the hole and give it enough time to cure before putting it back in service. Of course, if the toilet is less than a month old I suggest returning it and getting a new toilet.
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

Water leaks from tank to bowl till water level in the tank is jus


Yes. You will have to remove your tank from the bowl to replace the defective fill stack(the tube thing your flapper is attached to) it is not as hard as it seems.First remove water supply tube.Then remove the through the tank bolts. should be two of them. Lift off and turn tank upside down. remove spud gasket. Unscrew old stack. You should be able to get a universal kit to work with your tank and should come with all new parts including new flapper and spud gasket. You will need new through the tank bolts and note the sequence of assembly to get water tight seal on tank. Hope this helps
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

American Standard Elongated toilet bowl water level slowly drops


The tank holding the proper amount of water is a good sign. The inside of the stool is like the GOOSE NECK under you sink. It always holds water. This may sound like a bit of a hassle to do but if all 3 toilets are identical, here is what you can try if you are a bit handy. Go to the hardware store and purchase 4 toilet wax rings with a plastic flange and a few sets of toilet floor flange bolts(they are cheap and you can always return if not used, as It is better to have xtra parts on hand). Turn off the water supply to the "Mystery Toilet". Leave the tank and everything connected to the stool. Flush the toilet and remove all excess water from the tank and bowl. This can be done with a shop vac, sponge or towel. Disconnect the water supply to the tank. Remove the bolts holding the stool to the floor and carefully remove toilet. Scrap off all the old wax from the floor flange and bottom of stool. Now go and repeat this proceedure to one of the toilets that is working properly. In other words Switch the "Mystery Toilet" with a "Working Toilet" and see how they react. If the working toilet does it in the same bathroom and the "Mystery Toilet" does not do it in the other bathroom then you probably have a VENTING PROBLEM. If the "Mysery Toilet" Does it in the other bathroom then you most likely have a Defective Toilet. This Job is best done by 2 people, as it can sometimes be challenging to center the new wax ring on the toilet flange. Reconnect to the floor and reconnect water supply to the tanks. DO NOT OVERTIGHTEN BOLTS to the floor flange as you may crack the toilet. All drain lines must be vented properly for water to flow. If you are curious check out drain venting on the internet. Also, sometimes a vent can become obstructed with debris, ice, bird nest, etc.. I would 1st check the vent on the roof visually and then have someone flush and listen. If you believe the vent is clear....Then do the toilet switch and go from there.....Hope this helps and Happy Holidays....Joe
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Toilets are refilling between flushes


Replace the flappers, and clean around the flapper seat. Make sure the water level is 1/2 " below the large vertical tube by either bending the float rod down or adjust the skinny silver rod on a Fluidmaster unit.
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

I hear the water filling the every half hour i check there is no water leaking any where


This could be one of two things. Take the lid off the tank and add a few drops of food coloring and let it set, if the color shows up in the bowl you have what is called a silent leak. aka your flap is bad and only replace it with the exact factory flapper that your toilet came with. yes there are different ones and you will probably have more problems using after market parts.MAKE SURE THAT THE SEAT IS CLEAN AND FREE OF CALCIUM OR NICKS. The other problem although not as common check that the black inlet water tube is above the water line and that the water stops filling apx 1": below top of the white tube that fills the bowl.
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

Master bath toilet replaced with a Cimmeron class 6 confort height toilet. The master bath toilet backs up to the hall bath toilet - same wall. The hall toilet is very old. When the old toilet is flushed, water from the Cimmeron bowl flushes (leave the bowl) also. After 2 or 3 times flusing the old toilet, there is almost no water in the bowl of the Cimmeron. Called Kohler and they said they we probably need an off set Y - one higher than the other to fix the problem. Even if I switch out the old toilet for another Cimmeron, Kohler says that the problem will still exist. Does this sound right or is there another reason this may be happening?


Kohler is correct. The most likely cause of this problem is an obstruction in the common vent stack that both toilets share. When you flush the old toilet it need more air to flush and will get it from the easiest source (your new water saver toilet). First adjust the float level in the old toilet so it won't use as much water or just stick a brick in the tank to take up space.Second, run a snake down the vent stack from the roof to check for obstructions. Birds will sometimes nest in there.
Read More At : K-3489 Cimarron Comfort Height Elongated Toilet With......

I recently bought (9 months ago ) an american standard brand model CADET 3 one piece unit and recently 1 month ago , after flushing the toilet the water fills the up the water tank but there is continuous leaking(dribbling) of water into the the tube and the flushes are no longer as powerful as before. for your info the toilet was installed professionally.....what could be the problem and what recourse is there theunit cost was on speciall for $ 500.00


Theres probably debrie in flush valve, mite also try putting food dye in tank (any color) if it appears in bowl the flapper is seeping water and activating flush valve..
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

AS Toilet takes a long time to flush and flushes very slow.


Flapper needs to be adjusted or replaced
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

Champion Won't Flush


I would definitely follow your own advise Howard. Good luck
Read More At : 2002.014 - Champion4 Right Height Elongated Toilet......

I have a new American Standard Cadet 3 that was just installed. After flushing, the water fills into the bowl. However, after several minutes, the water in the bowl slowly drains away and is nearly gone. The flapper appears to be seated well and no sign of leaking. What is causing the water to drain from the bowl like this?


Sorry for problem with new toilet.You say water is leaking out of the bowl?Toilets have 2 parts:1) Tank: where water is stored for the flush and is sealed with a flapper.2) Bowl: where water flushes down.a) If tank is leaking water, then flapper is suspect. Replace flapper and see if that works.Lift up flapper and run finger around rim to see if there is a rough spot that would indicate flush valve is defective, and needs replacement.See typical flush valveb) If bowl is leaking, that is very unusual and would indicate a crack in the porcelain.If installer sold you the toilet, it is his responsibility to make good on product.All products are guarantee against workmanship flaws.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1066 seconds