Guide :Home : T13420 Chrome Classic Single Handle Monitor Pressure...

I have a Delta Series 1400 faucet in the tub/shower. The handle turns left and right for Hot & cold, but I do not know how to adjust total volumne. Is the round know supposed to pull out? It does not appear to tilt in any direction. I bought this house as a repo... bath looks new... but I can't get the faucet to work at all. The numbers on the inside brass are ASSE1016 P Delta.

Posted by roger_hanes on Dec 30, 2008

Research, Knowledge and Information :


Viewer Comments - DIY Plumbing Advice


Pressure balance valves are required to be hot left, cold right in ... Have a Delta shower/tub faucet that ... the Posi Temp valve only turns, it does not pull out, ...
Read More At : www.diyplumbingadvice.com...

Earn Miles by Linking Your Lyft and Delta Accounts


I have not flown on Delta for ... but it’s important to know that it doesn’t have any ... we’ll have to let the investigation run its course and see what turns ...
Read More At : lifehacker.com...

This Infographic Explains What to Do If Your Lyft Line Gets ...


... check out the infographic below. What to Do in a ... just because federal law does not criminalize ... but it’s important to know that it doesn’t have any ...
Read More At : lifehacker.com...

Comments | medicland.ru


Have a Delta shower/tub faucet that ... the Posi Temp valve only turns, it does not pull out, ... since faucets are factory set to hot-left & cold-right and ...
Read More At : medicland.ru...

Employee Injuries At The Tesla Factory Are Way ... - jalopnik.com


... and it was great seeing a talented artist quickly sketch out a new, never-before-seen character right ... have not yet had to handle ... I know these are not ...
Read More At : jalopnik.com...

Scientists Transplanted a Rat Testicle onto Another Rat's ...


It turns out, transplanting them ... The Best Stuff to Watch on Netflix Right Now That’s NOT in English. ... I didn’t know any of Terry Pratchett’s Igors was in ...
Read More At : gizmodo.com...

Amtrak's Summer Of Hell Is Here - Jalopnik


Amtrak's Summer Of Hell Is Here. Allana ... or have a commute-related rant you need to let out? ... his fix appears to have worked and left no visible evidence of ...
Read More At : jalopnik.com...

The Far-Right Alliance Is Over - Gizmodo


... any tenuous alliance that may have existed in America’s political far right is ... not been partially drowned out by ... Gizmodo: “I don’t have any ...
Read More At : gizmodo.com...

Answers - A place to go for all the Questions and Answers you ...


Questions and Answers from the Community. Go. ... How many people are in the world right now? ... you need to have an account.
Read More At : www.answers.com...

Suggested Questions And Answer :


I have a Delta Series 1400 faucet in the tub/shower. The handle turns left and right for Hot & cold, but I do not know how to adjust total volumne. Is the round know supposed to pull out? It does not appear to tilt in any direction. I bought this house as a repo... bath looks new... but I can't get the faucet to work at all. The numbers on the inside brass are ASSE1016 P Delta.


Hi roger, Sorry Delta 1300 and 1400 series valves do not have a volume control. Kinda odd but that is how they are made. Please rate this response and Good Luck, Phil
Read More At : T13420 Chrome Classic Single Handle Monitor Pressure......

We lost water flow to our bath tub faucet and associated shower head recently. I took off the shower head to confirm that the filter wasn't blocking flow there. We then had a plumbing company come out and take a look and they believed the issue to be with our Delta water mixer cartridge as there was a build up of sediment on the intakes and they could not clean it enough. I was able to track down a replacement cartridge but still nothing coming through. I then returned that in case the new cartridge was faulty. Still nothing. I turned the water back off, took out the cartridge completely and turned the water back on. Water comes gushing out of there into the bathtub so there is 100% no problem with water getting to the bathtub. If in theory the cartridge is working then after the handle is turned on it should then be pushing the water into the opening that goes into the copper pipe going to the faucet and shower head. These are new copper pipes which were put in within the last two years so it is impossible for there to be any kind of buildup on the pipe (sediment would not have been able to pass through Delta cartridge anyway). Water is not leaking as I can see the plumbing in the closet behind the tub. Drywall had been ripped out when plumbing work was done two years ago and not replaced. If the pressure was causing the water to get displaced anywhere else I would see it back there, but it is dry as a bone. Is it possible that all three cartridges (original plus two replacements) are all faulty? I have proven that water is getting to the point where the cartridge is installed but not getting beyond the cartridge. Is there something else I am missing? Installation of cartridge is cut and dry. It will only go in one way. I don't even have the whole assembly on while testing so I can leave the adjustment screw off and just using Vice-Grip to allow me to turn handle the whole way. Help !!!!!!!!!!


I'm thinking that the cartridge may not be turning with the handle. After attempting to turn the faucet on a few times, see if the teeth on it are worn.
Read More At : & Single Handle Shower Faucet...

Not enough hot water


Some higher end models do have an adjustment that is behind the face plate. You would have to remove the handle and the screws in the faceplate to expose them. If you have adjustments they will be located on the brass valve body facing you. You will need a flashlight and a flathead screwdriver to make the adjustment. If your model is not equipped with adjustments you could have a faulty valve stem. The stem is comprised of a rubber band like gasket that separates port holes into which the waters flow. There could be some piece of trash blocking the port not allowing adequate water from the hot side into the valve.Some valves stems are also able to be installed upside down causing the same issue as the ports do not rotate fully to allow adequate supply. However you say that you have adequate pressure on the hot side but not warm enough. There is another possibility also based on the way the shower supply was plumbed but there is no need to go into this unless this does not resolve your issue. I hope this is of assistance and thanks for using Fix Ya. Please let me know if I can be of further assistance.
Read More At : Home...

No hot water


Hes right adjust the temp. ring to hotter
Read More At : & Single Handle Shower Faucet...

I HAVE A DELTA SHOWER /TUB FAUCET THAT IS LEAKING. I KNOW HOW TO FIX THE LEAK BUT THE HANDLE WILL NOT COME OFF. I HAVE UNSCREWED AND TAKEN OUT THE HEX SCREW THAT HOLDS THE HANDLE ON. I HAVE PULLED, WIGGLED TO TRY AND GET THE HANDLE OFF WITH NO SUCCESS. IS THERE SOMETHING ELSE I'M MISSING. DO I HAVE CALCIUM BUILDUP SO BAD THAT I CAN'T REMOVE THE HANDLE? WHAT NEXT?


Calcium build up can adhere just like cement and cause sticking of the trim handle for faucets and showers. Hardware stores do sell handle pullers, but in my experience all you need is a rubber mallet and CAREFULLY hit the handle towards the wall(again carefully not hitting the wall). (This is assuming that your handle has a lever just like the one in the picture you've shown). Hit the lever towards the wall and give it a pull with your hands and repeat this till you get a little play. Once you get a little play, you just have to wiggle it till it comes out. Another tip is to spray the stem area with WD-40 and letting it sit for awhile making sure you wipe off the excess from dripping. Hope this helps.
Read More At : & Single Handle Shower Faucet...

Need to fix a leaking delta shower faucet and need to know how to take it apart. Single handle. only turns to left for on and farther left the hotter it gets,


Find the set screw on the handle loosen and remove handle, remove locking ring (a tool to do this comes with the replacement kit that you can buy from hardware store) remove the ball. You now have access to the washers and springs remove old washers and springs install new. reassemble in reverse. make sure not to overtighten locking ring.
Read More At : & Single Handle Shower Faucet...

I have a delta single handle shower faucet and I cant get the brass coler that holds the cartrage in any sugestions?


Hope you have the water shut off to the shower first! The collar you are referring to, does it look like a tuning fork? If so, it pulls upward from a little lip. Good luck
Read More At : & Single Handle Shower Faucet...

We have no hot water upstairs after installing our Delta Leland shower valve. We need to know how to get it to the on/off position because the handle is not on it at this time.


Off should be at the 6oclock
Read More At : & Single Handle Shower Faucet...

On my delta shower handle 1400 series i know my set screw is stripped and i can not get it off i really jus wanna break it off and buy a whole new one can someone help me out before i go crazy on the handle


You can use any high speed drill bit and drill the set screw out, it should be chrome plated brass, so, it will be soft. If you get your sizing right, maybe, just over the size of hex in set screw, you may be able to save the handle and get the rest of the set screw out. You could also try an "easy out" that will fit in the shole you drill to extract the set screw.
Read More At : & Single Handle Shower Faucet...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1249 seconds