Guide :Home : 86709 Atomic Wall Clock

I have 3 clocks w/ Temperature Transmitter 4.33MHz,all have quit

I have replaced the batteries in the proper sequence...not one of the 3 will work. Seems the clocks are fine. Thanks, Judi McLamb [email protected]

Research, Knowledge and Information :



GTX PLL reset problems at low die temperature 1d

The worst was the iPhone 4S which quit at 14F, and all ... Im also having temperature issues...i have 3 ... I know that Boost 2.0 will drop clocks, when temperature ...
Read More At :

MICROWIND User's Manual | Mosfet | Field Effect Transistor

MICROWIND User's Manual. ... The temperature is given in °C. 3.16 The PMOS Transistor The p-channel ... The default clocks assigned during compilation have been ...
Read More At :

Manual Motherboard Intel | Usb | Computer Hardware

... Power Type Operation Temperature Operating Humidity Size ( L x W ) ... PCI Bus Clock into 3 or 4 All ISA Signals can be ... To Manual Motherboard Intel
Read More At :


Read More At :


Read More At :

Hands on Virtex-5 XC5VLX110T-FF1136 pk

hi all. i have just got the Virtex-5 ... the DVI transmitter on page 15 does that. The 4 serial channels ... • Memory clocks and data strobes routed ...
Read More At :

A peek at computer electronics by ten mien - issuu Chapter 1. Introduction Let’s face it—we take electronics for granted. All of our modern conveniences, from dishwashers to MP3 players, have ...
Read More At :

Computer | Computer Data Storage | Central Processing Unit

We will discuss clocks and clock ... Universal asynchronous receiver transmitter To provide the two-way ... (computer end of lead) Pin 2 3 4 5 6 7 8 20 Function TD ...
Read More At :

Hans leads police to Nina's body - Google Groups

Hans leads police to Nina's body Showing 1-336 of 336 messages. ... if every smoker in this small country were to quit smoking now as we speak,
Read More At :

GE Vivid 5 Ultrasound - Service Manual | Electrostatic ...

GE Medical SystemsTechnical Publication Direction: FB091565 Revision 1 GE Medical Systems Vivid 5 Service Manual <...
Read More At :

01 January 1991 | Compact Disc | Television -

Dec 31, 1990 · Scribd es red social de lectura y publicación más importante del mundo. ... No Need to Quit Your Job or Go To School ... Those all have a male 9-pin
Read More At :

Suggested Questions And Answer :

I have an acurite atomic wall / weather clock but the outside temperature is reading blank. I changed the batteries in the transmitter but still no reading. Where can I purchase a new transmitter. The only numbers I can find on the clock read as follows: 6608a-750-77rx. Thank you for any help you can give me.

I had one of these a while back and it had a required sequence for putting in the batteries. When the signal dies and you have to replace the transmitter batteries and the clock batteries in a certain sequence. The transmitter batteries cannot just be replaced. You also had to remove the clock batteries, then put in the transmitter batteries, then replace the clock batteries.
Read More At : 86742 Digital Atomic Wall Clock...

Skyscan digital wall clock just quit showing outside temperature

You probably need to 'pair' the outdoor sensor with the main base: look for a 'channel' button, as these units usually can get information from several sensors and differentiate them by a channel number.
Read More At : 86742 Digital Atomic Wall Clock...

Outside temperature not working on Atomic Clock (was working last night). Changed the batteries in both the outside transmitter and the clock tonight. Clock reset within minutes, but the outside temperature still not showing on the clock. Please advise.

Hello lucy... you most likely have some corrosion in the outdoor component. Remove the batteries from the outdoor component and clean the battery contacts with the eraser end of a common pencil. Reinstall the batteries and then give it up to 8 hours to start reporting accurately again. Joe Thanks for choosing Fixya!
Read More At : 86709 Atomic Wall Clock...

My clock is nort showing up the outside tempertute

Seems to be a consistent problem with Skyscan. I have the 88800 model and my outdoor transmitter isn't transmitting the temperature either. We've replaced the batteries in both the transmitter and clock and nothing for outdoor temp. It's only been used for 9 months.
Read More At : 86709 Atomic Wall Clock...

Outside temperture my clock does not show outside temperture I too have changed batteries several times. My problem is an incorrect temperature is shown. I e-mailed Skyscan to determine if the Atomic Clock could be the problem and not the outdoor transmitter. That way I would'nt mind buying a new transmitter.

Try changing the batteries in the CLOCK. I had the same problem in a 3M similar clock and it didn't read the transmitter correctly or eventually, at all, when the CLOCK batteries were getting low.
Read More At : 86742 Digital Atomic Wall Clock...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0508 seconds