Guide :Home : Satin Nickel Soap Dispenser...

Soap dispenser leaks

We have a Grohe satin nickle soap dispenser that works, but seeps soap around the bottom edges. Can it be fixed? Doesn't look like the washer comes out readily to replace it.

Research, Knowledge and Information :


Soap dispenser leaking - Houzz


Mine only leaks when I've just filled it and added too much detergent. If you pump some back into the bottle will that help? (I love the soap dispenser an wouldn't ...
Read More At : ths.gardenweb.com...

leaky Grohe soap dispenser - Forum - Bob Vila


Built-in kitchen soap dispenser. Grohe mod 28.857 (not absolutely positive of mod#). Leaks soap after a couple of uses. Rubber seal looks fine. Soap i...
Read More At : www.bobvila.com...

soap dispenser : Target


Shop for soap dispenser online on Target.com. Find soap dispenser ... the pump leaks soap from ... iTouchless Sensor Soap Dispenser dispenses soap on demand ...
Read More At : www.target.com...

Amazon.com: soap dispenser


2 Pack, 16 oz. Liquid Soap Dispenser with Stainless Steel Pump, BONUS PUMP included, Refillable Round Clear Glass Bottle, Perfect for Liquid Soap, Essential Oils and ...

Soap/Lotion Dispenser : Bathroom Accessories : Target


Shop Target for Soap/Lotion Dispenser bathroom accessories you will love at great low prices. ... Now it leaks rust all over the counter ...
Read More At : www.target.com...

Is your countertop soap dispenser a test of patience? - Houzz


Does your liquid soap always come out on its first pump? If the answer is yes, did you make any improvement/modification to your soap dispenser? I like the look of ...
Read More At : ths.gardenweb.com...

Amazon.com: Customer reviews: Grohe 45 260 800 Pump Only for ...


Find helpful customer reviews and review ratings for Grohe 45 260 800 Pump Only for Soap ... had a very leaky soap dispenser replaced pump and now no more leaks ...

Dripping soap dispensers - CMM Online


Dustin, What type of soap dispenser is it? A metal one like a Bobrick? Or, one of the hand soap manufacturers like Sani-Fresh, Johnson Diversey, etc?
Read More At : forums.cmmonline.com...

Soap & Lotion Dispensers - Kitchen Faucets - The Home Depot


Shop our selection of Soap & Lotion Dispensers in the Kitchen ... The Opulence soap and lotion dispenser is ideal The Opulence soap and lotion dispenser is ideal for ...
Read More At : www.homedepot.com...

Soap Dispenser Leak, Soap Dispenser Leak Suppliers and ...


Soap Dispenser Leak, Wholesale Various High Quality Soap Dispenser Leak Products from Global Soap Dispenser Leak Suppliers and Soap Dispenser Leak Factory,Importer ...
Read More At : www.alibaba.com...

Suggested Questions And Answer :


Bottle under Grohe soap dispenser leaks down to cabinet


Pull the dispenser out the top and have someone hold the trim above the counter while you tighen the bottle down below. But the real problem is the retaiher nut which hold the dispenser in place is loose. Remove the bottle underneath ( it unthreads) and tighten the nut that you see just above the bottle. This can be a tight spot and you may need a basin wrench. Please rate this response and Good Luck, Phil
Read More At : Satin Nickel Soap Dispenser......

Soap Dispenser leaks soap onto counter


Maby minor crack between the the treds on the bottle that screws in to the pump or a crack in the bottom of the pump and you may not see it because the pressure of the pump isint in the bottle when you un screw it tot look at it
Read More At : Satin Nickel Soap Dispenser......

Dispenser will not press down - Grohe Satin Nickel Soap Dispenser...


Unfortunelately for you, Grohe, does not offer pump head replacement to the best of my knowledge. The entire pump/bottle therefore will have to be purchased. You didn't mention what finish you had so if you plan to stay where you are for a long time I would suggest you look at the Rohl soap dispensers as an alternative. Their warranty is for 10 years and you can run a 3/8" I.D. vinyl tubing from the pump down to any size jug of soap you want under the sink and never have to refill it again from above. The finish might not be a match however.
Read More At : Satin Nickel Soap Dispenser......

I have a Grohe soap dispenser and it has quit working for me. It is as if it gets stuck after you push it down and it seems to leak the soap out of the bottom part of the dispenser getting soap all over counter. Then I have to pull it back up manually. I have cleaned it as good as I can but nothing I have tried works so I was curious to know if there is something I can do to repair it. The faucet & dispenser are approximately 6 years old. Any help would be appreciated.


Sounds like there might simply be old soap caked on the inside of the dispenser head and feed tube. Best thing to do is have a sink filled with HOT water and just put the head portion in there to soak for a while. This should loosen the old soap enough to either dissolve or at least get it moving again. You can also take what soap is still in the dispenser out and put in another container, taking time to rinse the container with hot water as well and then filling it with hot water as well to test the pump action of the head, again using this action to help clean the insides of the pump. Short of this doing the trick, it may just be time for a new one. Good luck.
Read More At : Satin Nickel Soap Dispenser......

Soap dispenser leaks


You can fill these 2 ways.You can pull out pump from top,at sink , and squeeze soap in .Or you can unscrew bottle from under sink and fill, I'm thinking that your bottle is loose under sink, or the plastic neck has a hairline crack. Im not real clear on where the soap is comming from.Thankyou.
Read More At : Satin Nickel Soap Dispenser......

My grohe soap dispenser won't pump out any soap.


If the soap dispenser is not pumping the soap then the soap is to thick. You need to then the soap down some so it will pump.
Read More At : Satin Nickel Soap Dispenser......

Will not pump even though full - Grohe Satin Nickel Soap Dispenser...


The pump mechanism may be worn out. Try taking the pump and soaking it in a mixture of 50% water and 50% soap scum remover. The mechanism may simply be clogged with detergent. If you have recently changed your detergent it may be too thick for the pump to push it out. Try thinning it with water and retrying. If none of these remedies work then you will have to replace it. You can usually get a replacement pump from your local hardware store. Try also contacting the manufacturer. They may provide a replacement part at low or no cost to you. Good luck.
Read More At : Satin Nickel Soap Dispenser......

My Grohe soap dispenser leaks under the sink. The bottle simply hangs off the pump. It looks like it should screw on the dispenser but there was no nut. Is this correct?


Virtually all soap/lotion bottles have threads on the top of the bottle and are designed for initial installation only since all if them are refillable by pulling up on the pump head. Grab the bottle and twist to the right. If it will not tighten then the threads are stripped out and complet dispenser replacement is required. Grohe does not sell either the pump assembly nor the bottle separately.
Read More At : Satin Nickel Soap Dispenser......

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0378 seconds