Guide :Home : Home

No water coming out from the shawer head

Water comes out of a little plastic pipe that is beneath the electric shawer but not from the shoer head. Water all splashes from beneath the electric shower body

Research, Knowledge and Information :

Shower Repair : How to Fix a Tub Faucet When Water Comes Out ...

Jan 25, 2012 · If water is coming out of both the head and the faucet of your shower, you have a problem. Fix a tub when water comes out of the head and faucet with help ...

Plumbing Problems: Shower Water Not Getting Hot - SF Gate

The hot water heater is where you begin to find out why your ... Plumbing Problems: Shower Water Not ... But keep in mind that the hot water coming from a shower is ...
Read More At :

no hot water to moen tub shower valve - YouTube

Oct 25, 2014 · Find out why Close. no hot water to moen tub shower valve steven lavimoniere. Loading ... How to fix no hot water shower - Duration: ...

no hot water flow at shower - Community Forums

i could really use some advice on this before i start ripping walls apart. the hot water at my shower is only coming out as a trickle. the cold water
Read More At :

No hot water in shower but plenty of hot water at sink!

Although hot water runs out of the basin tap in the bathroom the shower flow is almost cold and the ... No Hot Water to shower head, ... Water coming up in ...
Read More At :

The Hot Water Is Not Working With the Moen Single Handle ...

The Hot Water Is Not Working With the Moen Single Handle ... of the cartridge before you pull it out. You may be able to restore hot water flow by rotating it 180 ...
Read More At :

Low Shower Head Water Pressure | Ask the Builder

Low Shower Head Water Pressure ... half inch diameter pipe that connected to the shower head. If lots of water comes out of the bent ... is coming out is ...
Read More At :

Suggested Questions And Answer :

Where can I get a shower head that doesn't restrict water flow?

If your problem is low pressure, your best bet is a pump. not sure if you can get them where you are. Are you in the USA? Try Canadian shower heads. Shower Pumps High Quality and Performance bathstore
Read More At : Home...

Little water comes out my shower head when I take a shower, should I call a plumber, or is this something that I can fix myself?

Remove the shower head. and if the water flows normal, its a clogged up shower head. if takeing a shower and the diverter valve goes bad. water will come out of the spout. check out shower head to see if its clogged. sometimes you can soak the head in a good cleaner and it helps it. but if its the showerhead thats plugged. you can always put a new one on also. good-day !
Read More At : Home...

No water coming out from the shawer head

No water usually means that the solenoid coil needs replacing. You can get them here:
Read More At : Home...

I'm not sure what brands my faucet or handles are.

You can remove the center (Diverter valve) without turning water off, Will need deep well socket. Check the o rings and or washers and replace or take valve to Home depot to match with new. If you can't find one there go to local plumbing supply or ace. I turn hot then cold on and off real Quick while the valve is out just to clear anything that might be in lines. stand to the side or you will get wet! You might want to get new hot and cold valves while your at it just make sure to turn off water at meter before you remove them.
Read More At : Home...

The water coming out the shower jets is not powerful, help?

Follow this steps and fix it. God bless you If a faucet leaks, replace seals and gaskets . If a shower head leaks, create a better seal or replace seals . If a sillcock wears out, replace the washers . If a compression faucet drips from the spout, replace the washer and/or the seat . If a faucet leaks from the handle, replace O-ring(s), replace the packing washer, tighten the packing nut, or replace worn packing, depending on the valve type . If a ball or cartridge faucet leaks from the collar, replace worn O-rings . If a disk faucet leaks around the base or has reduced flow, replace cracked or pitted disk assembly or worn inlet seals . If there is water under the sink, tighten the faucet-set locknuts under the sink. You also can replace putty or a gasket, replace a worn faucet, or replace leaky supply tubes . If the aerator leaks around the edge, replace the washer in the aerator . If the spray hose leaks or has reduced flow, replace the O-ring on the diverter valve, replace a worn washer at the base of the spray head, or clean the diverter valve and spray head .
Read More At : Home...

When i hooked up a delta faucet for a handicap tub i had to put it on the right side of the wall so that the older guy could reach the handle to turn the water on and he wanted the shower head closer

Not usually, but there should be an inverter or other unit to activate the shower. Often it is in the tub outlet and blocks the tub outlet to force water up the shower pipes. If there is no such or if it is just not working you may need to run the piping up to a sufficient height and then back down to the shower head to create enough pressure resistance if it is as you say, requiring a specific height of pipe to get a specific back pressure. But there also needs to be a mechanism to force the water up the shower pipe. Look up Delta on the web and get a phone number as there will be someone at Delta that can fully advise you about this.
Read More At : Delta...

We lost water flow to our bath tub faucet and associated shower head recently. I took off the shower head to confirm that the filter wasn't blocking flow there. We then had a plumbing company come out and take a look and they believed the issue to be with our Delta water mixer cartridge as there was a build up of sediment on the intakes and they could not clean it enough. I was able to track down a replacement cartridge but still nothing coming through. I then returned that in case the new cartridge was faulty. Still nothing. I turned the water back off, took out the cartridge completely and turned the water back on. Water comes gushing out of there into the bathtub so there is 100% no problem with water getting to the bathtub. If in theory the cartridge is working then after the handle is turned on it should then be pushing the water into the opening that goes into the copper pipe going to the faucet and shower head. These are new copper pipes which were put in within the last two years so it is impossible for there to be any kind of buildup on the pipe (sediment would not have been able to pass through Delta cartridge anyway). Water is not leaking as I can see the plumbing in the closet behind the tub. Drywall had been ripped out when plumbing work was done two years ago and not replaced. If the pressure was causing the water to get displaced anywhere else I would see it back there, but it is dry as a bone. Is it possible that all three cartridges (original plus two replacements) are all faulty? I have proven that water is getting to the point where the cartridge is installed but not getting beyond the cartridge. Is there something else I am missing? Installation of cartridge is cut and dry. It will only go in one way. I don't even have the whole assembly on while testing so I can leave the adjustment screw off and just using Vice-Grip to allow me to turn handle the whole way. Help !!!!!!!!!!

I'm thinking that the cartridge may not be turning with the handle. After attempting to turn the faucet on a few times, see if the teeth on it are worn.
Read More At : & Single Handle Shower Faucet...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.1082 seconds