Guide :Home : Home

Bathtub jacuzzi (motor turns on but nothing comes out of jets)

I fill up the tub and turn on the jets but noting is coming out of the jets. What does this mean? Is this something that i can fix myself?Any help would be greatly appreciated.Thanks

Research, Knowledge and Information :


5 Common Hot Tub Issues and Solutions - Swim University | The ...


Here is a list of some common hot tub issues and ... My hot tub is running, but nothing is coming through the ... the bearings in the motor are going out, ...
Read More At : www.swimuniversity.com...

the pump on my hot tub works but the jet's don't turn on ...


Myles if you turn on your pump and you hear the regular sound coming from the motor but you ... hot tub has 2 jets and a ... hot tub today. Turns out it ...
Read More At : aqua-tech.ca...

Hot Tub Pump Problems - HotTubWorks


... and you can test the power coming in and out of them to ... turn the shaft, to rule out a locked up motor, ... hot tub pump problems, hot tub ...
Read More At : www.hottubworks.com...

Jetted tub doesn't work. - That Home Site! Forums


... but nothing at all comes out of the jets. ... When the unit turns on, does the motor sound like ... Bathtubs Liberate Your Bathroom With a Freestanding Bathtub ...
Read More At : ths.gardenweb.com...

Why Aren't My Bathtub Jets Working? | Pro Referral


Why Aren't My Bathtub Jets Working? ... it’s necessary to bleed the air out of plumbing lines to enable the jets to work ... the Jacuzzi’s pump motor may be ...
Read More At : www.proreferral.com...

Jetted Tub Question When I press the button to turn on the


... When I press the button to turn on the jets, nothing ... it seemed as if the water was not coming out of the jets as ... It is actually a hot tub site but ...
Read More At : www.justanswer.com...

Nordic Hot Tubs - Why does nothing come out of the jets?


Question: When I turn on the jets, they run but there is nothing coming out the jets. What could be the problem? Answer: Most likely the tub has an airlock, if you ...
Read More At : www.nordichottubs.com...

Suggested Questions And Answer :


Bathtub jacuzzi (motor turns runs but nothing coming from jets)


Each Jet will have an adjustment many times right on the jet nozzle. Carefully try to rotate them counter clockwise to open up the jet. This assumes you can here the motor running. Phil
Read More At : Home...

Bathtub jacuzzi (motor turns on but nothing comes out of jets)


Open the the repiar panel and see if the pump is working. you may hear the motor running but not the pump.
Read More At : Home...

Jacuzzi jets not pumping out water


I have a garden tub and some of the jets work and some do not could this still be my pump?
Read More At : Home...

Just drained jacuzzi hot tub and replaced circulation pump. Went to turn back on and now nothing works. Can't lights to come on, motor on main hot tub doesn't even turn on. It flashes COOL / FLO2, but jets don't work. Tried pushing all buttons and still nothing.


Bleed pump check fuses and connections
Read More At : Home...

Rapid Heater for Jacuzzi


The light is supposed to be on when the tub is full of water and the pump comes on. Make sure the heater is plugged into a seperate breaker, it cannot be on the same line as the pump.Look on the heater for a label. If your heater is installed on the discharge side of the pump it should say "pressure heater" on it. If it is installed in front of the pump it should say "Vacuum Heater" on it.Once installed, fill the tub with water and turn the pump on. If it is installed in the correct position the light will come on when the pump turns on.
Read More At : RapidHeat In-Line Heater U395000 [ Bathtubs and Whirlpools,...

Aquglass jet tub will only humm no bubbles out of none of the jet


When a motor hums, it usually is the result of what is called "locked rotor." This can occur when the motor's brushes remain on one pair of the commutator contacts. The magnetic field does not shift to the next set of windings and the rotor is locked in place by the unchanging magnetic field. If you have access to the motor, turn on the power briefly and place your hand gently on the side of the motor. Probably you will feel the vibration of the hum you are hearing, together with some heat. In locked-rotor condition, the motor draws high amperage and heats up quickly. Turn off the power.If this is the condition, the motor is shot and needs to be replaced. You should copy down the information from the name plate (model and serial number, manufacturer, horsepower, amperage, etc.) and contact the manufacturer or a local appliance parts store about a replacement.As you said that you recently bought the house, you may have a home-owners warranty which may cover the appliance.
Read More At : Safety Bath Walk In Bathtub - Stretch Without...

Bathtub jets will not start


Our reset for the jets were hidden in the master closet behind the tub. We also found another access point to the tubs inner workings in the same place. Also, make sure they open all the air intakes and the tub is filled prior to testing. On ours if water is not above a certain level it won't come on.
Read More At : Home...

I just installed a Jacuzzi Fuzion corner tub and the pump will not come on. When I plugged it up, it made a noise for about 30 seconds (and the LED lights on the control panel looked lit up as if it were going through a cycle.) It stopped and the lights went off. I filled it with water and pushed the button to turn on the jets. The 4 LEd lights beside the button ran through twice, but the pump did nothing. The lights in the tub turn on and work fine. Any idea what could cause the pump not to come on?


Should of primed it first ?
Read More At : Fuzion Whirlpool...

I just purchased this tub and have installed it in my home i am renovating. to control the tub, it only has one button/panel on the inside of the tub, however, my plumber tells me that there are two nozzles that need holes drilled and a control panel trim kit installed on the back side of the tub where the motor is - is this correct? I can see the nozzles he is referring to on the underside of the tub above the motor, however, when i contact Jacuzzi directly, they inform me that this is not correct. I can not seem to get a straight answer - am i actually supposed to do something with these nozzles or is the one button the full function of controlling the jets? There does not appear to be a speed control or anything like that - just one on/off button. HELP!


Normally the jet pump is a two speed motor so you can have more or less air to the jets. I would go by the mfg. recommendation fully on this. They know what the tub is designed for and what installation requires. The plumber may want to run up the bill a bit on you, not saying that he is, but...
Read More At : 5' Jacuzzi Tub Bathtub Cetra 532 H525-969...

Jacuzzi bathtub problem


Hi gmaynardo, I'm Harvey the Master Plumber. Your question is can the switch work after it is dryed out? First, it is important to understand that none of the electrical equipment (i.e. pumps, switches, wires etc.) installed on a whirlpool of any type is designed to survive under water for any length of time. Just because it is working after drying does not mean you are home free. Corrosion, rust and electrolisis are now likely, not to forget the very real chance of electrical fire. All is not lost. I would recomend replacing al inexpensive components but the pump may be handled a little differently. Since it is the single most expensive part it would be wise to take it to a local small motor repair man for inspection. With a thumbs up from him I would be very happy. Feel free contact me again!Please give me a rating here at fixya.com before you sign offThank you, Harvey
Read More At : Home...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0689 seconds