Guide :Home : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet

American standard cadet 3 leaking around seal

I installed the above about 1 year ago. Shortly after installation, the toilet would start to refill about 1-2 times an hour. I took the top off and you could see and hear it leaking slightly thus why the refill. The setup is unique and simple but I have tried everything from adjusting the way the seal is seated to replacing the seal/rubber gasket. Sometimes when you flush the seal doesn't seat properly and the toilet leaks constantly and refills every 5 minutes. I either flush toilet again or adjust the seal and the problem seems to go away until the next flush. Any thoughts?

Research, Knowledge and Information :


American Standard Champion Toilet Leak Repairs - 411 Plumb


American Standard was right about the ... Standard line including the highly successful Cadet 3 ... of a leaking American Standard Champion Toilet with the ...
Read More At : 411plumb.com...

3 in. Tank-to-Bowl Gasket for American Standard Cadet 3 Toilets


Fluidmaster - 3 in. Tank-to-Bowl Gasket for American Standard Cadet 3 Toilets - Help prevent leaks between a toilet tank and bowl with this gasket, featuring foam ...
Read More At : www.homedepot.com...

American Standard Cadet 3 Factory Leak, Fix Info In Text ...


Jun 30, 2015 · I bought this American Standard Cadet 3 toilet and installed it. About an hour later there was a small puddle of water behind the toilet. I found water was ...

Problem with the Flapper on American Standard Cadet 3, 4027 ...


Problem with the Flapper on American Standard Cadet 3, ... a leaking flapper. ... run your finger around the seal where the flapper goes.
Read More At : terrylove.com...

3 in. Toilet Tank Replacement Flush Seal for American ...


Adds a traditional style and classic design to your bathroom. The Keeney Manufacturing Company 3 in. Toilet Tank Replacement Flush Seal for American Standard Cadet ...
Read More At : www.homedepot.com...

American Standard 047188-0070A Tank to Bowl Coupling Kit ...


American Standard 047188-0070A ... Coupling Kit for American Standard CADET 3.5 GPFTOILET 2334 SERIES ROUND ... the seal around the bolts in the tank kept leaking.

New AS Cadet 3 tank leak | Terry Love Plumbing & Remodel DIY ...


New AS Cadet 3 tank leak. ... the dumb system American Standard uses for the Cadet 3 tank-to ... They do this because it can help guarantee a good seal around the ...
Read More At : terrylove.com...

repair - Toilet leaks 4-6 months after wax ring replacement ...


Toilet leaks 4-6 months after wax ring replacement. ... My toilet is an American Standard Cadet 3, ... so the leak is around the base when the toilet is flushed?
Read More At : diy.stackexchange.com...

Suggested Questions And Answer :


American standard cadet 3 leaking around seal


There is none. I thought I had an unusual case but after replace numerous flappers (some purchased and some sent by AS, this toilet will continue to leak into the bowl. American Standard sent a new complete flush valve and that did not work. This toilet has leaked for 4 years now and I have to shut the water off manually. Good flush, bad design for water retention. Contacting AS two weeks ago asking for a replacement tank has met with stall while they review. I'm done waiting. Two Kohlers in the house do not leak a drip. Guess what happens today? If I do not have contact back today I'm going to the local home center and buying a Kohler, and will be a stuanch critic of AS fixtures in that aisle from this day forward. They know anout this but can not fix it. Cram that five year warranty. Like the line in the movie said, "Guaranteed, I can sh** in the box and mark it guaranteed, and you would have a guaranteed piece of sh**.
Read More At : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet...

Hi, I want to replace an old American Standard toilet bowl that is a 4 bolt tie down design to the floor. Can I replace this with a standard 2 bolt floor mount design? If not are 4 bolt tie down models still available and if not what modification do I need to do to install a standard 2 bolt tie down design?


If you go with the 2 bolt you will need (I presume) to drill 2 holes into the tile. put toilet in place where it will sit and mark the holes , take away toilet and drill the holes with a 7ml tile drill bit (masking tape put over the tile will help you to not slip when starting off the hole). Drill deep enough to insert 7ml rawl plugs. then place the toilet back and fix down with screws long enough to go through the toilet and 3/4 of the rawl plug. You will need; Electric percussion drill or descent battery drill. 7 ml tile drill bit 2 x rawl plug 7ml 2 x screw masking tape is handy hope this helps, Alex
Read More At : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet...

American Standard Elongated toilet bowl water level slowly drops


The tank holding the proper amount of water is a good sign. The inside of the stool is like the GOOSE NECK under you sink. It always holds water. This may sound like a bit of a hassle to do but if all 3 toilets are identical, here is what you can try if you are a bit handy. Go to the hardware store and purchase 4 toilet wax rings with a plastic flange and a few sets of toilet floor flange bolts(they are cheap and you can always return if not used, as It is better to have xtra parts on hand). Turn off the water supply to the "Mystery Toilet". Leave the tank and everything connected to the stool. Flush the toilet and remove all excess water from the tank and bowl. This can be done with a shop vac, sponge or towel. Disconnect the water supply to the tank. Remove the bolts holding the stool to the floor and carefully remove toilet. Scrap off all the old wax from the floor flange and bottom of stool. Now go and repeat this proceedure to one of the toilets that is working properly. In other words Switch the "Mystery Toilet" with a "Working Toilet" and see how they react. If the working toilet does it in the same bathroom and the "Mystery Toilet" does not do it in the other bathroom then you probably have a VENTING PROBLEM. If the "Mysery Toilet" Does it in the other bathroom then you most likely have a Defective Toilet. This Job is best done by 2 people, as it can sometimes be challenging to center the new wax ring on the toilet flange. Reconnect to the floor and reconnect water supply to the tanks. DO NOT OVERTIGHTEN BOLTS to the floor flange as you may crack the toilet. All drain lines must be vented properly for water to flow. If you are curious check out drain venting on the internet. Also, sometimes a vent can become obstructed with debris, ice, bird nest, etc.. I would 1st check the vent on the roof visually and then have someone flush and listen. If you believe the vent is clear....Then do the toilet switch and go from there.....Hope this helps and Happy Holidays....Joe
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

I recently bought (9 months ago ) an american standard brand model CADET 3 one piece unit and recently 1 month ago , after flushing the toilet the water fills the up the water tank but there is continuous leaking(dribbling) of water into the the tube and the flushes are no longer as powerful as before. for your info the toilet was installed professionally.....what could be the problem and what recourse is there theunit cost was on speciall for $ 500.00


Theres probably debrie in flush valve, mite also try putting food dye in tank (any color) if it appears in bowl the flapper is seeping water and activating flush valve..
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Toilet handle stick on flush and water runs and runs before we are aware of it


Turn water off and get a handle repair kit, very easy repair
Read More At : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet...

The fill valve in my toilet tank leaks.and water level can not be


There are different fill valves if you have the one w/ two screws on top you have to tie down the one on your left hand side if you have the one w/ a side plastic long screw adjust that one
Read More At : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet...

Toilet will not flush fast enough


The chain that connects to the flap has too much slack you have to ajust it by switching the chain up a little so the flap will open all the way
Read More At : 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet...

My brand new toilet american standard round front model cadet 3 tank not fill water


If you verify that the water supply to the toilet is turned on, push down the float on the flush valve. Water should start flowing. If it doesn't, something (such as debris) may be blocking the valve and preventing filling. The new valve could be defective - permanently closed.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

I have a new American Standard Cadet 3 that was just installed. After flushing, the water fills into the bowl. However, after several minutes, the water in the bowl slowly drains away and is nearly gone. The flapper appears to be seated well and no sign of leaking. What is causing the water to drain from the bowl like this?


Sorry for problem with new toilet.You say water is leaking out of the bowl?Toilets have 2 parts:1) Tank: where water is stored for the flush and is sealed with a flapper.2) Bowl: where water flushes down.a) If tank is leaking water, then flapper is suspect. Replace flapper and see if that works.Lift up flapper and run finger around rim to see if there is a rough spot that would indicate flush valve is defective, and needs replacement.See typical flush valveb) If bowl is leaking, that is very unusual and would indicate a crack in the porcelain.If installer sold you the toilet, it is his responsibility to make good on product.All products are guarantee against workmanship flaws.
Read More At : Cadet 3 Right Height Elongated Toilet by - ADA Compliant...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1099 seconds