Guide :Home : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091

Toilet water wont go down

When i flush my toilet all the water and everything in it comes to the rim of the toilet and wont go down after a min or two it will go down a little just under the rim i have tried everything plunging it and it don't works cleaning the little holes that the water comes out of don't work

Research, Knowledge and Information :


Toilet Doesn't Fully Empty - How to Make Sure Water Filters Fast


Sometimes when I flush the toilet, everything doesn't go down. Sometimes the toilet just fills with water and NOTHING goes down! What causes this to happen?
Read More At : www.naturalhandyman.com...

Why won't the water go down when the toilet is flushed ...


If the water in the toilet does not go down when flushed, the toilet may be clogged. The clog may be completely blocking the pipes....
Read More At : www.reference.com...

Toilet not flushing properly.Auger and plunger don't make a ...


Aug 23, 2011 · Toilet not flushing properly.Auger and plunger don't make ... Toilet won't Flush water stays in bowl Easy ... toilet will not flush water stays in ...

What could cause the water in a toilet to swirl but never go ...


Water in toilet won't go downSounds like it's clogged up. The water enters the toilet bowl on an angle, so it will always swirl because of that angle,.
Read More At : www.answers.com...

How to Unclog a Toilet | Digital Trends


The next step is to turn off the water to the toilet. ... of the plunger, but make sure it doesn’t go down the hole and make ... water goes down the ...
Read More At : www.digitaltrends.com...

Toilet problems, repair toilet blockage or toilet is blocked ...


Toilet Problems And Repair Toilet blockage or ... The water will not go down at all and will ... there or it will make it around but won't go through the hole ...
Read More At : www.cidnetwork.net...

Toilet swirls, but won't flush!! - Houzz


Toilet swirls, but won't ... Because the water has to go into the bowl quickly ... first I poured one and a half gallons water down the toilet to see if it would ...
Read More At : ths.gardenweb.com...

7 Ways to Unclog a Toilet - wikiHow


Sep 14, 2016 · How to Unclog a Toilet. ... A small amount of water won't work, ... Added some household cleaner and hot water, and we are good to go. Thanks for the ...
Read More At : www.wikihow.com...

Suggested Questions And Answer :


Toilet water wont go down


I have found on many occasions this problem was caused by an obstuction in the internal trap of the toilet. Everything from toothbrushes to Batman figurines have been removed from them. If you intend to do the repair yourself you can use a closet augerwhich is a manual cable snake tool that will be inserted into the bowl of the toilet and the cable ran through the toilet's internal trap to clear obstructions. You could also rent a hand held electric auger that is basically a drill with a drum attached with a drum with coiled cable inside that is shoved down the channel the same as the aforementioned product. This device take a bit of finesse and skill as the cable will try to kink and coil up as you go one can get injured doing this. If you find that the toilet is clear of internal obstructions you may have to pull the toilet up as the obstruction may be further down the line. If you rent a medium sized electric auger you can locate the vent stack for the toilet and run your cable down the vent from the roof so you may not have to pull the toilet. This method will only clear obstructions behind the vent connection and not the length from the connection of the vent to the toilet itself. If yo have an elevated house you may have access to a clean out that by most codes are at every change of direction greter or equal to ninety degrees. You also should test your water pressure if all else fails as that specific model must have at least 25 psi at the very least to operate correctly. Hope this helps you out.
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

The water continue to run for a long time


You are probably going to have to replace the fill valve. There is a chance that adjusting it may work, but it has most likely become worn and partially clogged with hard watrer deposits, dirt, etc. This will cause it to fill slower, and cause the fill level valve to close slower resulting in higher water level. Eventually it would simply overflow the flush valve tube. Try adjusting the fill level, but plan on the likelyhood of replacing the fill valve.
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

No water at flush


Sound like the water shut-off needs to be replaced. if you turn on/off the shut-off, the tank get enough water to flush, then you get less water every time you use the toilet. that is the shut-off valve problem. you may able to to just change the rubber seal. I have not found change the seal will last as long as a new valve. better off, just change one.
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

Eljer pressure assist handle will not move. If water valve is on, water will conitnuously run with no shut off


If you take the lid off the toilet there is a cartridge in the middle of the tank. if you take the handle mechanism off the toilet and get some plyers you can take the cartridge out of the tank by twisting it out. make sure the water is off and that you have pressed it down ( the part that stick out of the middle of the cartridge)to relieve the pressure. it should come right out and take it to a local plumbing supply shop and they should be able to get you a replacement part for it.
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

Eljer toilet my toilet clogges since dropping a blue water tab, but my question is what do i do to fix whenthe water rises and flushes very slowly?


1) Get rid of those tablets 2) carefully, remove remaining tablet in the tank. Try not to disturb the dissolving tablet. Try covering with small plastic bag, gathering the bottoom together and quickly lifting it out and into the trash. 2) Take either a wire hanger or nail and clean ou all of the small holes around the top of your toilet bowl, undetneath the rim of the seat ring. They are clogged with pill residue. 3) Inside base of bowl, at bottom front is an inlet the stirs the water sothat it all goes down. This inlet is probably clogged with a hard residue. Use either the nail or a serrated steak knife to chip away this residue. It is not slimy; it seems hard as stone and will come off a little at a time. 4) As the residue collects in bottom of bowl, flush toilet, until it works right. It will take a while. I know, I just did this ast night!!!
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

Toilet tank looses water over time


As long as there is no water leaking from the tank to bowl connection, you are OK. You would know if it was leaking here, because you would have water dripping out onto the floor. Verify that the water level in your tank is below the top of your new flush valve's overflow tube. If the water level comes to the top, it will overflow into the toilet bowl. This can be easily fixed with an adjustment to the fill valve. If the water is not overflowing into this tube, then the only way you can lose water is through the flapper. You said you changed the flush valve, which would have come with a new flapper attached to it, but maybe buy a new flapper and see what happens???
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

No back flush pressure


Increase the tank water level half inch at a time till you have the back flush pressure. seems like the water in the bowl is too low to create any wirlpool.
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

Elijer Diplomat toilet flushes perfectly, but after the water in the bowl takes forever to fill up again. You have to wait 10-15 min. before the water is up to normal level and it will then flush normally.


Pressure assisted toilets have a stainless steel tank that refills under lid,if your refilling bowl it only needs to fill trap for smell,the pressure assist does the rest,thats part of the water saving of the toilet,you don't have a lot of water in the bowl
Read More At : Aqua-Saver 12" Two-Piece Pressure-Assist Toilet - 091...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || diydecoridea.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0858 seconds